|
REIN PSH0453
|
|
$6.12
Price
|
$0.00
Core
|
+ Sold in packs of 1x1
Pack
|
$6.12
Total
|
|
|
|
|
|
| REIN PSH0453 Specifications |
|---|
| Clamps Included | Yes | | End 1 Inside Diameter (MM) | 10.0000 | | End 1 Outside Diameter (MM) | 18.0000 | | End 2 Inside Diameter (MM) | 10.0000 | | End 2 Outside Diameter (MM) | 18.0000 | | Heat Shield Included | Not Required | | Hose Burst Pressure PSI | 750 | | Hose Line Lining | SBR Rubber | | Hose Line Outer Material | Rubber | | Hose Material | NBR/CR | | Hose Operating Pressure PSI | 250 | | Mounting Bracket Bushings Included | Not Required | | Mounting Brackets Included | Not Required | | Power Steering Fitting Included | No | | Protective Sleeve Included | Not Required |
|
|
Features:- A direct fit, replacement hose with clamps
- OE quality, braided rubber compound hose
- Pre attached mounting bracket bushing(s), protective jacket(s) and heat sleeve(s), where required
- Ensures proper operation of the power steering system
 Installation Tips - Replace all power steering hoses at the same time, to prevent system contamination
- Completely flush the system with an OE approved Power Steering Fluid prior to installation (the correct type of fluid is noted on the reservoir cap or in your owner's manual). Flushing the system is critical to prevent system contamination and failure
- Install the replacement hose in reverse order of how it was removed, making sure to install any included o-rings. Lubricate the o-rings with Silicone Grease and carefully install them, to prevent damage. Make sure the hose is not touching or rubbing against any components that vibrate or give off heat
- Consider installing a Power Steering Filter on the Power Steering Return Hose to prevent system contamination and extend the life of the power steering components
|
| OEM / Interchange Numbers: 4441204010 |
REIN Warranty Information:24 Months, 24,000 Miles |
|
