|
GMB 5302085
|
|
$163.79
Price
|
$0.00
Core
|
+ Sold in packs of 1x1
Pack
|
$163.79
Total
|
|
|
|
|
|
| The float arm (where pictured) may ship detached to prevent damage in transit. To connect, simply snap the wire end into the sender hole. |
| GMB 5302085 Specifications |
|---|
| Fuel Sending Unit Included | No | | Fuel Type | Gasoline | | Mounting Hardware Included | 1 O-ring |
|
|
Fuel Pumps are essential to delivering the required amount of fuel from the fuel tank to the engine. Each GMB Fuel Pump goes through 3 points of inspection; at the development stage, manufacturing stage, and prior to shipment to ensure you receive a high quality pump that delivers a long service life.
Features & Benefits:
- 100% Pressure and Flow-rate tested in-house
- Durability tested during development for longer life
- Designed to reduce noise
- Includes all required hardware for installation
 Benefits of Purchasing a Fuel Pump & Housing Assembly Purchasing just the fuel pump is less expensive up-front, but a complete Fuel Pump & Housing Assembly provides added benefits:
- Extend Service Life: New strainer(s), hoses, sensors and other components help resolve problems that could be caused by more than just the pump.
- Reduce Install Time: Since you don't have to disassemble the housing, which could lead to damage, replacement becomes a simple swap, dramatically reducing installation time.
- Save Money: The cost of the assembly is often cheaper than buying the components individually, and means you only have to do the job once.
 Prevent Premature Fuel Pump Failure Preventing premature fuel pump failure is far less expensive and time consuming than continuing to replace the pump. There are three common causes for premature fuel pump failure:
| ELECTRICAL ISSUES |
Poor electrical connections will mimic symptoms of a failed pump, sometimes resulting in unnecessary replacement. Before replacing the pump:
- Use a Fuel System Tester to test pump pressure is within expected range
- Use an Electrical Tester to test for bad wiring, burnt or corroded connectors
- Check / Replace faulty Fuse(s) and Relay
BEFORE REPLACEMENT |
| FUEL CONTAMINATION |
Dirt, rust or debris in the fuel can clog strainers and stick to internal pump components. When replacing the pump:
- Replace Fuel Filter or Fuel Strainer
- Empty and clean the tank with Fuel Tank Cleaner
- Fill tank with fresh, uncontaminated fuel of appropriate grade
DURING REPLACEMENT |
| PUMP DAMAGE / OVERHEATING |
Running low on gas causes your fuel to heat up quicker, and your pump to work harder. After replacing the pump:
- Maintain at least 1/4 tank of fuel and use a Fuel Additive / Conditioner to keep pump cool and lubricated
- If vehicle is stored without use, drain tank to prevent pump corrosion from fuel oxidation
AFTER REPLACEMENT |
 Additional Resources
When Is It Time to Replace Your Fuel Pump?
|
| OEM / Interchange Numbers: 21015072, P494M |
GMB Warranty Information:12 month/12,000 miles |
|
